Starter shingles go on under the first row of shingle.
Starter row and first row of shingles on the roof.
To prepare the tabs and lay the starter course shorten the first starter shingle by 6 inches or about a half of one tab.
Lay the first row of shingles directly covering the narrow starter row.
It is packaged two pieces per shingle 16 shingles per bundle.
If you are making your own starter shingles cut the tabs off for the starter course bottom row of shingles.
Every roof has to start somewhere and that somewhere is at the appropriately named starter shingle also called starter strip.
Use the chalk line to snap a straight line vertically every 6 inches.
Perforated down the center for easy separation.
These shingles are instrumental in making sure the asphalt shingles are correctly laid out on your roof.
Snap a horizontal chalk line over the starting row to use as a guide.
Use your chalk and tape measure to mark about 12 inches up on the roof for the first set of shingles.
On the rake gable edges of the roof starter has 2 functions.
Owens corning starter strip shingle helps save time by eliminating the need to cut shingles to create a starter row.
Since that row doesn t have a shingle below it to protect the seams the starter shingles act as that barrier.
Before you can begin setting asphalt shingles on your roof you must install a row of starter shingles.
If these first shingles are not installed correctly there will be problems with the entire set of shingles.
They re meant to be installed under the first row of roof shingles surrounding the perimeter of the roof.
Repeat this on both sides of the roof.
Armour starter if you have selected iko s armourshake shingles for your roof you will need to use iko armour starter.
Starter shingles are the initial shingle products installed on the roof just before the first course of the finish shingles which will comprise the visible parts of the roof.
Cut six inches off the length of the first starter shingle nailed on then use the rest of them full size.
Place the glue strip at and all along the drip edge and the rake edges as well.
Every 5 inches make a new mark until you get to the rop of the roof.
Installed below the first row of shingles and along roof rake edges roof starters literally get your roof started in the right direction.